Inflatable Pub Hire

Guide · Homeowners · 4 min read · Updated 17 November 2026

How Much Space Do You Need for an Inflatable Pub?

Short answer

Allow the pub's footprint plus at least one to two metres clear on every side. A small pub typically needs around 4 by 3 metres, a medium pub about 5 by 4 metres and a large pub 6 by 5 metres or more, before the safety margin. The ground should be level and free of sharp objects, with a power socket within about 25 metres and a clear route for the crew.

How Much Space Do You Need for an Inflatable Pub?

Footprint sizes by pub type

Exact dimensions vary between manufacturers, so always check the specific unit, but the figures below are a reliable starting point. The extra clearance is not optional. It gives room for anchor straps, the blower tube, guests stepping in and out, and the wall flexing in a breeze without touching fences or plants.

Pub sizeTypical footprintSpace to allow including clearanceGuests
SmallAbout 4m x 3mAbout 6m x 5mUp to 15
MediumAbout 5m x 4mAbout 7m x 6m15–25
LargeAbout 6m x 5m or moreAbout 8m x 7m or more30–40

The right kind of ground

A flat lawn is ideal because it allows the unit to be staked through its anchor points, which is the most secure method. The crew will check the grass for stones, sticks, dog mess and anything sharp, and will lay a ground sheet under the pub to protect both the fabric and your lawn. A gentle slope is usually workable, but a noticeable one makes the floor uneven inside and puts strain on the seams.

Patios, decking, tarmac and artificial grass can all work, but stakes cannot go in, so the pub must be held down with heavy weights or sandbags instead. Tell us about hard surfaces at the quote stage so the crew bring enough ballast. Avoid placing the pub under trees that drop sap or branches, and keep it well away from ponds, barbecues and fire pits.

Power and the blower

An inflatable pub stays up because an electric blower runs continuously, pushing air in faster than it escapes through the seams. Switch it off and the pub starts to sag within minutes. That means it needs a reliable power supply for the whole hire, ideally an outdoor socket protected by an RCD within about 25 metres. Long extension reels should be fully unwound to stop them overheating, and cables should be run where people will not trip over them.

If there is no suitable socket, a quiet petrol or inverter generator can be supplied. Never share the blower's circuit with a patio heater, kettle or sound system that might trip the supply, because a sudden loss of air mid-party is the most common avoidable problem.

Access for the crew

A packed inflatable pub is heavy and bulky. Crews usually move it on a sack truck or rolling trolley, so they need a clear, firm route from the van to the set-up spot. Gates of at least a metre wide are helpful, steps slow things down, and narrow side alleys can be a challenge. If the only route is through the house, say so in advance so the crew can bring floor protection and plan the lift.

  • Clear a parking space close to the property for the van on the day.
  • Measure the narrowest gate or passage on the route.
  • Count any steps between the road and the garden.
  • Move cars, bikes and garden furniture before the crew arrive.
  • Keep pets indoors while the pub is unloaded and inflated.
  • Mow the lawn a day or two before, not the morning of the hire.

Positioning the pub for the best result

Where you put the pub in the garden makes a big difference to how well it works. Facing the entrance towards the house or the main seating area draws guests in and makes the bar the natural centre of the party. Keeping it out of direct line of the prevailing wind reduces strain on the anchors, so on an exposed site it can help to tuck it behind a hedge, a fence or a building, as long as there is still clearance on every side. The crew will advise on the best spot when they arrive, but having an idea in advance saves time.

Think about the evening too. If there is a projector or television for a match, the pub's opening should face the screen, and the screen should be shaded from low sun. If music is playing, keep speakers pointed away from neighbours. For lighting, a pub positioned near the house can often share the same outdoor socket as festoons on the patio, but the blower should always have priority on its own supply.

Last of all, leave a clear path from the pub to the toilet and the kitchen. Guests will make that trip many times, and a well planned route keeps them off flower beds and away from cables.

What happens on the day

Most crews arrive a couple of hours before your guests. They lay the ground sheet, unroll the pub, connect the blower, inflate it, then secure every anchor point with stakes or ballast. A typical set-up takes thirty to sixty minutes. Before leaving, they walk you through the safety basics: keep the blower clear, do not let anyone climb the walls, and deflate the pub if wind picks up or rain becomes heavy.

At the end of the hire the crew switch off, let the air out, roll the pub up and take everything away. If the fabric is wet, it will be dried at the yard, so you do not need to worry about rain at collection time. Leaving the area tidy of cups and bottles makes the pack-down quicker.

Questions people also ask

Can an inflatable pub go on a patio?

Yes, as long as the patio is large enough for the footprint plus clearance. Because stakes cannot be driven into paving, the pub is held down with heavy weights or sandbags attached to each anchor point. Let the hire company know in advance so they bring enough ballast, and check there are no raised edges or planters that could damage the base.

Can I put an inflatable pub indoors?

Many inflatable pubs can go inside a large hall, barn or function room, provided the ceiling is high enough with clearance above the roof and there is a socket nearby. Indoors is often easier because wind is not a concern. Check the venue's rules first, as some halls restrict inflatables or ask to see the hire company's insurance and inspection paperwork.

How much power does an inflatable pub use?

A typical blower for an inflatable pub draws roughly the same as a domestic kettle running continuously at low load, so it plugs into a normal 13-amp socket. It should have its own socket rather than sharing a busy extension with other appliances. If lighting is fitted inside, that adds very little. A generator is only needed where there is no suitable outdoor supply.

Written and checked by the Inflatable Pub Hire team. Read our editorial policy.

Get a free inflatable pub hire quote

Tell us what you need and we'll come back with a clear price.

Request a quote